Knowing the basics about your automatic pool cover is key to a happy, stress-free swim season. There are a variety of potential causes for the motor or controller of an automatic pool cover to not open and close as it should.įix or replace? Your local automatic pool cover service company can most likely fix or replace the motor or controller. If the cover is failing to open or close properly, you’ll need to have an automatic pool cover specialist take a look at the system to diagnose the problem. However, gliders are a wear item and if the gliders are worn, but the rest of the cover is in good shape, they can most likely be replaced to extend the functionality of the pool cover system.ĥ. If the track has debris built up, it must be sprayed out with a low-pressure hose nozzle.įix or replace? Tracks rarely need replaced. The gliders need to be in good shape to keep the automatic pool cover opening and closing smoothly. Aluminum tracks are found on both sides of the pool and need to be clear of debris. They can be replaced as long as the vinyl and webbing are still in good shape.Ĥ. Ropes typically can not be repaired, but need replaced when they are worn or frayed.įix or replace? The ropes should last the lifetime of an automatic pool cover depending on use and maintenance of the system. If they are, you’ll need to give a local pool cover specialist a call. Check the ropes to make sure they’re not worn or frayed. The ropes attach to the webbing and pull the automatic cover closed. If it’s tearing or catching as it enters the track, the webbing and/or pool cover will likely need replaced.ģ. Depending on how bad the wear and tear is, webbing may be repairable.įix or replace? The webbing is a key component of the overall safety of an automatic pool cover. As you inspect the webbing, look for worn, frayed webbing or webbing that has separated from the vinyl. It slides back and forth inside the track and holds the cover above the pool water. The webbing is the 2” material on the side of every automatic pool cover. Holes more than 6 inches definitely need to have an expert technician take a look at it.Ģ. Continuing to patch holes in the cover instead of replacing it can compromise the integrity of the cover and the safety of your family. Remember that a persistent puddle of water in the same spot is a dead giveaway that there’s a hole or tear allowing pool water to seep through.įix or replace? What starts as wear or a tiny hole can quickly turn into a bigger problem. However, if you find larger holes or tears, or if the vinyl is worn, it might be time to think about a new cover. If you find a hole that’s less than two inches in diameter, or a tear that’s less than three inches long, that may be able to be fixed with a patch kit. You’re looking for faded worn areas, small holes or tears. It is important to take a close look at the entire cover. Let’s take a look at components of an automatic pool cover system, and how you might be able to determine if they can be repaired, or if it’s time to call a pool cover professional to replace these automatic pool cover parts.ġ.The vinyl. However, depending on the age of the cover and how well it has been maintained, it might be time to replace it. An automatic pool cover contains parts that can be repaired. To fix it, or to replace your automatic pool cover? That is the question.Īs you walk around your pool, you should visually inspect your automatic pool cover from time to time, because you may not know it but it may have some potential service issues.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |